the cable connectors are color-coordinated with the corresponding connectors on the back of the viewstation and the optional network interface modules. to connect the viewstation, use the quickstart card as a guide and follow the steps below.
1. place the viewstation unit on top of the television monitor as shown in figure 1-1. ensure that the front lip of the viewstation unit hangs over the edge of the television monitor.
verify that the top surface area on the monitor is adequate to support the viewstation. the surface area of the television monitor should provide enough support to prevent the viewstation from sliding off the monitor.
2. connect the required cables to the back of the viewstation as shown in the viewstation quickstart card.
3. center the microphone pod on a flat surface between the meeting participants and the viewstation.
4. connect optional equipment, such as an additional television monitor, a video cassette recorder (vcr), a laptop, or a document camera to the back of the viewstation.
secure all loose cables with the provided cable tie. this prevents cables from getting tangled.
1. slide one end of the cable tie through the square plastic cable holder.
2. attach the square connector to the back of the television monitor.