cable diagrams and pinout schematics are located in v.35 technical information," on page 193.
connecting the v.35 network interface module to the viewstation
complete the following steps to connect the v.35 network interface module to the viewstation:
1. connect the green-tipped rj-45 cable to the green rj-45 port on the back of the viewstation.
connecting the v.35 network interface module to the v.35
dce
complete the following steps to connect the v.35 network interface module to the v.35 dce:
1. connect the male hd-25 cable ends to ports 1 and 2 on the network interface module. if you want to connect only one cable, connect to port 1 on the interface module.
connector screws should be lightly snug, not tight.
2. connect the remaining cable ends to the dce v.35/rs-449 port and the db-25/rs-366 dialing port, if used. if connecting one cable only, connect to the lowest ordered port on the dce.
led activity on the v.35 network interface module
the leds on the front of the v.35 network interface module indicate the connection status to the viewstation.
when the viewstation is powered on, the following light sequence occurs:
1. both leds flash once to indicate that the led is working properly.
2. the bottom amber led glows solid to indicate that the viewstation is communicating with the network interface module.
3. the top green led glows solid to indicate that the viewstation is communicating with the network.
the top green led corresponds to port status, and the bottom amber led corresponds to dce clock status.
once the interface is properly connected, the viewstation h.323 with v.35 is ready to be configured for ethernet lan connectivity.