about condensation

    if the machine is moved from a cold to a warm place, it is possible that condensation may form on the scanning glass, preventing proper scanning of documents for transmission. to remove the condensation, turn on the power and wait approximately two hours before using the machine.

    connecting the handset

    connect the handset as shown and place it on the handset rest.

    the ends of the handset cord are identical, so they will go into either jack.

   

   

    connecting the power cord

    plug the power cord into a 120 v, 60 hz, grounded ac (3-prong) outlet.

    do not plug the power cord into any other kind of outlet. this will damage the machine and is not covered under the warranty.

   

   

    if your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for the power and telephone lines. surge protectors can be purchased at most telephone specialty stores.

    connecting the telephone line cord

    insert one end of the line cord into the jack on the back of the machine marked tel. line. insert the other end into a standard (rj11c) single-line wall telephone jack.

   

   

    the fax machine is set for tone dialing. if you are on a pulse dial line, you must set the fax machine for pulse dialing. press the keys on the operation panel as follows:

   

    attaching the tray extension and document support

    attach the paper tray extension.

    pull the paper release plate forward. insert the paper tray extension horizontally into the notches in the paper tray. rotate the paper tray extension up until it snaps into place.

   

   

    the original document support has a top side and a bottom side. if you cannot insert the tabs on the support into the holes, turn the support over.

    extension phone (optional)

    if desired, you can connect an extension phone to the tel. set jack on the fax.

    to connect an answering machine to your fax, see chapter 7, answering machine hookup (page 88).