set the date and time by pressing the keys on the operation panel as shown below.

    do not set the date and time if you are using openlcr!

    openlcr automatically sets the date and time each time your fax calls openlcr and receives rate data. to ensure accurate use of the rate data, do not change the date and time setting yourself. openlcr also sets the date and time for you if you perform the fax transmission test (see page 40).

   

    the imaging film and printing paper must be loaded before the date and time can be set.

   

   

   

   

    4 enter a two-digit number for the month (?1?for january, ?2?for february, ?2?for december, etc.).

    to correct a mistake, press the speed dial key to move the cursor back to the mistake and then enter the correct number.

   

   

   

    7 enter a two-digit number for the hour (“01” to “12”) and a two-digit number for the minute (“00” to “59”).

   

   

    daylight saving time

    if desired, you can set the clock to move forward and backward automatically at the beginning and end of daylight saving time. to turn on this function, press the panel keys as follows: