1 load the document(s) face down.
(maximum of 10 pages.) the display will show:ready to send
set the resolution and/or contrast if desired. (the default setting for copying is super fine.).
(1) if you are only making one copy of the original (or of each original) and don't want to make a reduction or enlargement setting, press the start/memory key twice. copying will begin.
(2) if you are only making one copy of the original (or of each original) and want to make an enlargement or reduction setting, press the start/memory key and go to step 5.
3 press 1 (multi copy) if you do not want the copies sorted. press 2 (sort copy) if you want the copies sorted.
4 if you are making one copy per original, press the start/ memory key. if you are making multiple copies per original, enter the number of copies per original (if the number is less than 10, enter a "0" before the number).
the display will show: copy ratio
5 set the amount of reduction or enlargement by entering a number from 1 to 5 as shown below, or press the start/memory key to automatically select 100%). copying will begin.
1: auto (automatic size adjustment to match the size of the printing paper)
2: 50%
3: 100% (no reduction or enlargement)
4: 125%
5: 135%
if you place a large number of originals in the feeder, the memory may become full before all of them can be scanned (memory is full will appear in the display). if this happens, press the start/memory key to copy the originals which have been scanned, and then repeat the copy procedure for the remaining originals, including the original which was being scanned when the memory became full.
copy cut-off
when making a copy of a document that is longer than the printing paper, use the copy cut-off setting to select whether the remaining part of the document will be cut off or printed on a second page. the intial setting is yes (cut off the remainder). to change the setting, follow the steps below.
2 press 1 to set copy cut-off to yes (the remaining part of the document will not be printed), or 2 to set copy cutoff to no (the remaining part will be printed on a second page).
the display will show:initialize film
