installation- keyboard wedge

    1) first of all, you must switch off the terminal/computer.

    2) disconnect the keyboard cable from the back of the terminal/computer.

    3) connect the appropriate interface cable to the scanner and to the terminal/computer.

    4) turn the terminal/computer power on.

    rs-232

    1) disconnect power to the terminal/computer.

    2) connect the appropriate interface cable and external power supply (dc adapter) to the scanner.

    3) plug the serial connector into the serial port on the back of your computer/terminal. tighten the two screws to secure the connector to the port.

    4) plug the power pack into power source.

    5) once the scanner has been fully connected, turn the terminal/computer power back on

    usb

    一、usb (simulate with rs-232, only for win 2000,win me)

    1) connect the usb cable between scanner and pc.

    2) windows will automatically detect the usb device.

    3) the driver setup appears. insert the cd-rom into your pc

    4) install the usb driver. (firmware must be version 3.00 or up.)

    5) refer to interface selection (p11), set usb to enable.

    二、usb (simulate with keyboard wedge)

    1) connect the usb cable between scanner and pc.

    2) windows will automatically detect the usb device.

    if any of the above operation is incorrect, turn off the power immediately and checking any improper connections. go through all above steps again.