1 set the power switch to on ( | ).
(1)" ┏" will flash on the multi-copy/error indicator when the thermal transfer film has run out.
2 push down the printer open lever and open the printer door.
3 insert the four gears into the new thermal transfer film.
(2)csecurely align the gear tabs with the grooves in the thermal transfer film and insert them as far as they will go. cthere is a blue gear and three green gears which need to be attached as shown in the figure on the right.
cthere is a blue gear and three green gears which need to be attached as shown in the figure on the right.
4 load the thermal transfer film into the film cassette.
(3)load the thermal transfer film into the film cassette so that the blue gear inserted in the thermal transfer film is located on the blue label side of the film cassette. push in the direction of the arrow until you hear all four gear shafts click in place.
5 if the thermal transfer film is slack, take up the tack by winding the gears on the label side of the cassette in the direction of the arrows.
(4)the multi-copy/error indicator may flash " ┎" if the thermal transfer film is slack. in addition, the therma transfer film may wrinkle, and blank (unprinted) spots or black streaks may appear on the copy paper.
6 install the film cassette.
(5)insert the film cassette into the printer so thathe blue gear on the cassette aligns with the blue label on the printer and then insert thegear shafts on both sides of the cassette intothe grooves inside the printer.
(6)if the film is slack after loading the film cassette, take up the slack in the same manner described in step 5 while the cassette remains loaded.
7 close the printer door.
(7)securely close the printer door by using both hands until a click is heard.
(8)the "┎ " flashing on the multi-copy/error indicator will go out.
if the flashing " " does not go out even though the printer door has been closed, this indicates that the film cassette has not beeninstalled properly or that there is slack in the thermal transfer film. check the condition of the film cassette and for slack in the thermal transfer film.