notes on loading copy paper
follow the guidelines below to ensure smooth and accurate printing by the unit.
(1)only use letter size copying paper having a weight of 60 to 90g/m2 (16 to 24 lbs) as the copy paper for this unit.
(2)do not simultaneously load paper of varying type and thickness as this may result in paper jams.
(3)before adding copy paper, be sure to remove all copy paper remaining inside the unit's paper cover.
: that copy paper will slightly resist being removed, but may be pulled out without problems.) after removing the copy paper, stack the removed paper together with the new paper, fan it thoroughly, square it and reload.
do not use the following types of paper
(1)extremely smooth or glossy paper
(2)coated paper
(3)thermal paper
(4)paper that is printed on one side
(5)wrinkled paper, creased paper, etc.
1 set the power switch to on ( | ).
(1)"┏ " will flash on the multi-copy/error indicator when copy paper has run out.
be absolutely sure to check that the power is on when loading copy paper as it will not load properly otherwise.
2 pull the paper cover forward as shown in the right figure.
the magnets are used as fasteners to hold the paper cover closed.
3 to prevent paper jams such as those caused by multiple sheets feeding, once fan the paper thoroughly, square it, align it with the guide inside, and insert as far as it will go.
(1)only use letter size copying paper having a weight of 60 to 90g/m2 (16 to 24 lbs) as the copy paper for this unit.
(2)do not stack more copy paper in the unit than the maximum paper limit indicated by the guide (see figure to the right) as this may result in paper jams. [the unit can hold about 80 sheets of paper having a weight of 80g/m2 (21 lbs).]
4 close the paper cover.
