1 push down the printer open lever to open the printer door.

   

    2 remove the film cassette with both hands.

   

    3 remove all jammed paper.

   

    4 if the thermal transfer film is slack, take up the slack by winding the gears on the label side the cassette in the direction of the arrows.

    (1)the multi-copy/error indicator may flash

    " ┏" if the thermal transfer film is slack. in addition, the thermal transfer film may wrinkle, and blank (unprinted) spots or black streaks may appear on the copy paper.

   

    5 install the film cassette.

    (1)insert the film cassette into the printer so that the blue gear on the cassette aligns with the blue label on the printer and then insert the gear shafts on both sides of the cassette into the grooves inside the printer.

   

   

    (1) turn the power off and on.

    (2)open the paper cover and remove all copy paper remaining inside the unit's paper cover.

    that the copy paper will slightly resist being removed, but may be pulled out without problems.

   

    (3) to prevent paper jams such as those caused by multiple sheets feeding, once fan the paper thoroughly, square it, align it with the guide inside, and insert as far as it will go.

    do not stack more copy paper in the unit than the maximum paper limit indicated by the guide (see figure to the right) as this may result in paper jams. [note that the unit can hold about 80 sheets of paper having a weight of 80g/m2 (21 lbs).]

   

    (4) close the paper cover.