before attempting installation of this wall-mounting kit, we strongly recommend consulting with the building facility nor manager, engineer, or architect. the installer needs to know the type of construction used for the wall intended for this installation and the location of wall studs. selection of hardware is critical for safe wall-mounting, and dependent upon the nature of wall construction, installation should not occur until this consultation takes place.

    procedure for kx-b063 wall-mounting kit installation

    1 tools required：one (1) kx-b063 kit

    a minimum of eight (8) pieces of appropriate wall-support hardware (molley, toggle, etc.)

    this hardware must be locally procured, it is not included in the kit.

    drill (and drill bit of correct size) for hardware installation screw driver (both phillips (+) and slotted (-) will be required.) tape measure tape or thumb-tacks (2pcs) bubble type level

    2 pre-requisites

    1. before installation, make sure that the wall intended for installation is capable of supporting flush-mounted.

    [ kx-bp800 is 103 kgf (227 ibs). ]

    2. the position of the intended installation is of adequate size for the selected panaboard.

    [ kx-bp800 is 1,575 mm x 1,524 mm (5'2"55').]

    3. an outlet is within 3 m (9'104/32"), and it is not located directly behind the panaboard.

    accessories

    the package includes the parts noted below ; please confirm that all parts are present before beginning installation. eight screws for mounting the fixtures on the wall are not provided. please purchase the appropriate wall-mounting hardware (sold in stores). refer to pages 83 and 84.

   

    wall-mounting procedure

   

    2 tape the wall-mounting template to the wall.

    (1)do not use the template included in the wall-mounting kit (kx-b063), but rather the one included with the electronic print board (kx-bp800).

    (2)when taping the template to the wall, make sure it is level.

    3 (1)drill holes in the wall for the wall-mounting fixtures. (8 holes total)

    (2)after removing the wall-mounting template, attach the wall-mounting fixtures with the appropriate wall-mounting hardware (two screws in each fixture).

   

    attaching the wall-mounting fixtures

    the electronic print board must be mounted with the method most suited to the material of the wall. three methods are presented here. (other options may be available in your area.)

    battaching to metal or concrete walls stud plugs (sold in stores) are needed.

   

    battaching to plasterboard walls split-wing toggles (sold in stores) are needed.