一、clearing errors
when an user recoverable error occurs, check led blinks to alarm you and the error message is displayed on the lcd. here is an example of an error message.
you can not clear errors with check led lit. they are not user recoverable and check led stays lit.
refer to “appendix 3 messages of operator panel,” ”error message (temporary error)” for the messages.
二、lifting or lowering the hopper
when the scanner has no error state (check led is not lit), the hopper height position can be changed.
during hopper height adjustment, do not put your hands or anything on or under the hopper to prevent your fingers from getting caught and injured.
if something is caught in the mechanism, the scanner may be damaged.
the hopper height adjustment function is not valid when:
1 read led is lit
2 the scanning operation is in progress
3 the scanner is in test mode (excluding single feed and multi feed)
4 the scanner is in setup mode
1. when the hopper is at the bottom position, it moves up to 250 sheet position.
2. when the hopper is at 250 sheet position, it moves down to the bottom position.
3. when the hopper is at the highest position, it moves back where it was when the scan operation started.
the hopper is positioned at the bottom when the power is turned on.
1. when the hopper is at the bottom position, it moves up to 250 sheet position.
2. when the hopper is at 250 sheet position, it moves down to the bottom position.
3. when the hopper is at the highest position, it moves back where it was when the scan operation started.
the hopper is positioned at the bottom when the power is turned on.
三、clearing the consumables replacement message
this scanner has the abrasion counters to estimate life of the consumables. when a counters, a counter for the pad assy, the pick roller unit, the brake roller unit, the frontside lamp or the back-side lamp reaches the pre-set value, the lcd shows a message that the consumable have expired. here is an example of the error messages.
enter setup mode. (for the details on how to enter the setup mode, refer to "chapter 7 operator panel menus"
at this screen, you can select the consumable counter to reset. for the details on how to clear consumable counter, please refer to the section “7.3 setup mode details,” “9. abrasion counter reset.”
四、using the setup and the test modes.
this scanner has the setup mode to customize the setup conditions, and test mode to test the scanner offline.
there are two types of setup modes: a online setup mode that can be entered during ready status and a offline setup mode that can be entered only when the scanner is offline.
available functions differ with the two modes. for the details, refer to "chapter 7 operator panel menus"
to enter these mode, follow the instructions below:
1 online setup mode
2 offline setup mode and online setup mode
to exit this mode, turn off the power.