1 be careful not to get injured during jam removal.
2 when removing jammed documents, be careful not to get your neckties or necklaces entangled inside the scanners.
3 the surface of the glass sometimes becomes hot during operation. take care not to get burned.
一、removing jams from the hopper or the transport path
1. remove the documents on the stacker.
2. pull up on the lever on the right front of the upper transport and then raise it.
raise the upper transport unit fully, then lower the transport to engage lock before you put your hands inside of the scanner.
3. while pulling the adf lever toward you, lift up the adf upper sheet guide.
4. remove the jammed document.
(1) staples and paper clips etc. can cause document jams.
(2) make sure you check the document and the document transport path for obstructions before you start scanning again.
(3) remove staples and paper clips from the documents before you start scanning.
5. lower the adf upper sheet guide carefully.
6. lift the upper transport unit fully to release the safety lock and then lower the transport unit carefully.
二、removing jams from the eject mechanism.
1. remove the documents on the stacker.
2. pull up on the lever on the right front of the upper transport and then raise it.
3. pull out the jammed document to the stacker.
4. lift the upper transport unit fully to release the safety lock and then lower the transport unit carefully.
三、document separation force adjustment
if the following error occurs frequently, adjust the brake force of the brake roller using setup mode.
1 double-feed
2 mis-pick
3 paper jam1
1. enter into the setup mode.
please refer to the section "1.3 basic operations of operator panel", "using the setup and test mode."
the following screen appears.
choose an appropriate setting based on the thickness of the document you are scanning and the error.
document separation force setup items are as follows.
if mis-pick occurs frequently, adjust the pick roller rotation speed.
the blinking item is the one selected.
when you set pick speed at "mid" or "slow", scanning speed is reduced.