there are two types of setup mode: online setup mode that can be entered when the scanner is in ”ready” status, and offline setup mode that can be entered only when the scanner is offline. available functions differ with the two modes.
to enter these modes, follow the instructions below:
(1) online setup mode
(2) offline setup mode
the blinking item is the one selected.
2 online setup mode restrictions
in online setup mode, the scanner setup can be changed without turning off the power.
however, the following items cannot be changed from this mode.
(1) consumables counter reset
(2) scsi id change
(3) product id change
(4) scsi bus width change
(5) interface change
(6) tps interface baud rate change
3 function of buttons in setup mode
4 transitions of screens in setup mode
refer to the next page lcd screen transitions chart for setup mode.
the lcd screen transition chart in the following pages show the concept. some of the details are not expressed in the chart.
the menu screens with dotted line frame appear only when the scanner is in offline setup mode
screen 22 and screen 23 appear only when tps interface board is installed. screen 24 appears only when both the fi-486prfr (front side imprinter) and the fi-486prre (rear side imprinter) are installed. screen 25, screen 26 and screen 29 appear when either or both of the fi-486prfr and the fi- 486prre are installed.