these warnings are translated into several languages in appendix e, “translated safety warnings.”

    this equipment is to be installed and maintained by service personnel only as defined by as/nzs 3260 clause 1.2.14.3 service personnel.

    only trained and qualified personnel should be allowed to install or replace this equipment.

    read the installation instructions before you connect the system to its power source.

    before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals.

    do not stack the chassis on any other equipment. if the chassis falls, it can cause severe bodily injury and equipment damage.

    the plug-socket combination must be accessible at all times because it serves as the main disconnecting device.

    to prevent the switch from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 113° f (45℃). to prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings.

    when installing or replacing the unit, the ground connection must always be made first and disconnected last.when installing or replacing the unit, the ground connection must always be made first and disconnected last.

    this equipment is intended to be grounded. ensure that the host is connected to earth ground during normal use.

    do not work on the system or connect or disconnect cables during periods of lightning activity.

    ultimate disposal of this product should be handled according to all national laws and regulations.

    attach only the cisco rps (model pwr675-ac-rps-n1) to the rps receptacle.

    class 1 laser product

    avoid exposure to the laser beam.