the switch is supplied with two mounting brackets and four screws. these are used for rack mounting the unit. when mounting the unit, you should take note of the guidelines given in “positioning the switch” on page 3.
rack mounting the units
the switch is 1u high and will fit a standard 19-inch rack.
disconnect all cables from the unit before continuing. remove the self-adhesive pads from the underside of the unit, if already fitted.
1 place the unit the right way up on a hard, flat surface with he front facing towards you.
2 locate a mounting bracket over the mounting holes on one side of the unit (refer to the figure following step 6).
3 insert the two screws supplied in the mounting kit and fully tighten with a suitable screwdriver.
4 repeat the two previous steps for the other side of the unit.
5 insert the unit into the 19-inch rack and secure with suitable screws (not provided).
6 reconnect all cables.
