ac power connection

    ac power should be supplied to the fcd-2 unit through the 1.5m (5 ft) standard power cable terminated with a standard 3-prong plug. the cable is provided with the unit.

    before switching on this instrument, the protective earth terminals of this instrument must be connected to the protective ground conductor of the power cord. the power plug shall only be inserted in a power outlet provided with a protective earth contact. the protective action must not be negated by use of an extension cord (power cable) without a protective conductor (grounding).

    make sure that only fuses with the required rated current, as marked on the fcd-2 rear panel, are used for replacement. the use of repaired fuses and the short-circuiting of fuse holders is forbidden.

    whenever it is likely that the protection offered by fuses has been impaired, the instrument must be made inoperative and be secured against any unintended operation.

    一、to connect ac power to fcd-2:

    1. check that the power switch on the fcd-2 rear panel is set to off.

    2. connect the power cable to the power connector on the fcd-2 rear panel.

    3. connect the power cable to the mains outlet.

    dc power connection

    二、to connect dc power to the fcd-2 unit:

    refer to the dc power supply connection supplement.