see section 2-4 for detailed information.

    psw jumper

    in general, you must enter a password when you start a control session. if the password is incorrect, fcd-2 will not respond.

    set the psw jumper as follows:

    1 user - in this position, you can define your own password and node address.

    2 init - set the jumper to init to restore the default fcd-2 password (fcd-2), and change the node address to the default value of 0. the change will be made after you turn fcd-2 off for a short time and then turn it back on.

    supervisory port configuration

    configure the fcd-2 sp port as required. see section 3.4.