1. during the control session, type the desired commands from the terminal keyboard. you must see the fcd-2 echo character by character.

    if a command is misspelled, backspace to clear the error, then type again the correct character.

    (1) after you typed the correct and complete command, press [enter] to execute the command. fcd-2 will process the command and send the appropriate response.

    at the end of the command execution, fcd-2 provides a new prompt for the next command line.

    (2) if you changed your mind, and want to abort the command, press [break]. you will again receive the prompt, so you can enter another command.

    you can use [break] to stop automatic repetition of commands sent with the/r option.

    2. if your command is not correct, fcd-2 will not execute it, but will echo again the command, with a bad command message in the following line. type again the correct command.

    3. if the terminal screen fills up during the exchange with fcd-2, you will see the message:

   

    after pressing any key except for [ break], the terminal scrolls to the next page.