1 turn the power off and unplug the power cord.
2 use your hand to pull towards you the front door release.
then open the front door completely.
3 place your finger on the paper feed roller block shaft and pull it towards you to remove the paper feed roller block from the magnet. (1)
push down the green levers and remove the paper feed roller module from the scanner by holding the green levers. (2)
(1) the paper feed roller block is attached by a magnet.
(2) when moving the green levers, do not apply pressure in any other direction than the arrows.
they may break.
4 open the optional "roller exchange kit (kv-ss009)", and take out the paper feed roller module.
for supplies and accessories:
call 1-800-346-4768 (u. s. a. only) or your dealer.
5 install the new paper feed roller module with the gear on the left side and the bearings into the guide grooves of the side chassis in the scanner. (1)
then push up the green levers on both ends until they click into place. (2) o match the paper feed roller module with the bearings and guide grooves, and then attach it.
6 push up on the paper feed roller block and it will magnetically attach to the chassis.
(1)?when attaching the paper feed roller block to the chassis, do not damage the roller.
(1)?you are now finished attaching the paper feed roller module.
to continue, replace the retard roller module according to the following procedure. (the retard roller module is located in the conveyor.)
7 pull open the conveyor towards you by using the indent on the right side.
(1)?when the conveyor is pulled towards you, the click-stop mechanism will be released.
(2)?when opening the conveyor, be careful not get your finger stuck in the indent.
8 pull the right side of the shaft in the direction of the arrow and hold it there. (1)
pull the retard roller module in the direction of the arrow (2) and then remove it.
9 take out the retard roller module in the optional "roller exchange kit (kvss009)".
for supplies and accessories:
call 1-800-346-4768 (u. s. a. only) or your dealer.
10 pull the right side of the shaft in the direction of the arrow and hold it there.(1)
attach the new retard roller module as shown in the diagram on the right (2) and then return the right side of the shaft in the direction of the arrow. (3) o confirm if pin a and pin b are inserted in their notches correctly.
o attach the retard roller module so that the notch a is on the left side.
11 hold the conveyor using both hands, and close the conveyor by pushing it into the unit.
(1) when the conveyor is closed, the clickstop mechanism will operate.
(2) if the conveyor is not closed correctly and the operation in step 12 is done, the conveyor may break.
12 close the front door.
(1)?push both sides of the front door down slowly until it clicks into place.
(2)?after replacing rollers, clear the eplace roll. warning?display.
(refer to page 28.)
