assists you to set the menu language, and automatically tunes in all the channels it can receive and sets the clock.

    the unit automatically determines the type of transmission (air or cable) and puts them into channels as follows.

   

    preparation

    1 confirm that the antenna is connected correctly.

    2 turn on the television and select the appropriate video input to suit the connections to this unit.

   

   

    3 press [enter].

    plug-in auto tuning starts and the unit puts the stations it can receive into channels.

    the unit then proceeds with auto clock setting. the time is displayed when finished. if the clock is an hour slower or faster than the actual time, go to “time zone adjust” to correct it (→page 47).

    4 when the display shows the correct time press [enter] to complete plug-in auto tuning.

    if the unit couldn’t set the clock automatically

    press [enter] to show the “manual clock setting” screen. set the time manually (→page 47).

    to start plug-in auto tuning again (after relocation, for example)

    antenna system, channel caption, and vcr plusr guide channel settings all revert to the default values when you perform the procedure below. timer recording settings are also cleared.

    when the unit is on and stopped

    1 press and hold [ˇ, ch] and [＾, ch] on the main unit for about five seconds.

    the unit turns off.

   

    if plug-in auto tuning fails

    1 press [setup] to show the menus.

   

   

   

   

    if you have not yet set clock, the “auto channel/clock setting” screen appears.

    6 press [enter].

    auto setting starts. this takes a few minutes. (to stop auto channel setting, press [return].) when finished, the complete screen or time display is shown. press [enter].

    to return to the previous screen

    press [return].

    when you are finished

    press [setup].

    adding and deleting channels

    add or delete channels if necessary channels are not set or unnecessary channels are set.

    while this unit is receiving the antenna signal (but not during recording):

    1 press the numbered buttons to select a channel.

   

    2 press [add/dlt].

    the channel is deleted if it was set or added if it was not set. e.g.,

   

    repeat steps 1 and 2 as necessary.