the diagram indicates the dimensions of the installation positions. the installation position is the same for both the standard type and the wide type.
the installation of the copyboard to the wall is performed after the printer tray is assembled and attached to the copyboard. see page 7.
[1] when the wall is concrete
embed the commercially available anchor bolts or anchor nuts for m6 at the installation positions. (see below)
[2] when the wall structure is plywood or plaster board, etc.
please check that a post or stud is located at the installation position indicated by the dimensions.
when a post is not located at the target installation position, please use a wall support fitting that is available separately. attach a wall support fitting to the post or stud.
1 when the building does not have posts, please use the stand.
2 separate optional items are available when the standard wall mounting is not possible, or when installation will be made to a partition.
reference: installation method for various wall materials
please perform an installation that suits the wall material.
please install the copyboard to posts or studs when the wall surface is of insufficient strength.
(2) attach the 4 supplied wall-mount brackets to the copyboard using m4 screws.
(3) attach the printer tray to the copyboard,
please see page 7 for information about the assembly and installation of the printer tray
*installation of the printer tray is not required when the copyboard is used only for memory storage.
(4) attaching and anchoring the copyboard to a wall or wall support fitting.
(the anchoring method will differ depending on the wall mounting method.)
