this is the height adjustment to the stand* at the time of setup. the height can be changed among 3 levels in 100 mm units (1770, 1870, and 1970 mm (the maximum height)).

    please lock the casters by pressing the lower portion of the lock buttons of them.

    (1) disconnect the power cable and all other cables.

    (2) take out the printer and remove the printer tray,

    remove the two m4 screws from bottom side of the printer stand and the other two from the rear surface.

    (3) remove the two locking screws (located at the left and right sides),

    (4) change the hole position of the copyboard rear frame.

    the copyboard will disengage from the hooks when it is lifted up about 1 cm.

    fully hook the (2 left and right) installation holes of the copyboard rear frame onto the hooks of the stand

    (5) attach the locking screws to the 2 locations (left and right) and tighten to the rear frames.

    (6) return to original by following the steps in reverse.

   

    * the stand may be an option.