1. attach the four blue wheel-shaped knobs at the points indicated in the figure below:
2. using three persons, grasp the handles located on each side of the system drawer, and lift the system drawer onto the extended rails. align the three screw holes in the inner rails with the screw holes in the sides of the system drawer.
3. using the six rail to system retaining screws, three on each side, mount the inner rails to each side of the system drawer. tighten each of the screws with a screwdriver or similar tool.
4. simultaneously depress the safety latches, located on each system rail assembly, and push the system into the rack.
5. slide the system drawer in and out of the rack two or three times. this action aligns the system drawer to the rails. the system drawer should glide on the rails.
6. push the system drawer back into the rack. using a screwdriver or similar tool, tighten the two rear retaining screws that secure the slide rails to the rack’s rear flange.
7. slide the system drawer about halfway out of the rack.
8. using a screwdriver or similar tool, tighten the front four retaining screws that secure the slide rails to the rack’s front flange.
after the system rails are installed, do not extend them past their safety latches. the safety release latches stop the rails from overextending and separating. this action prevents the system drawer from being accidentally pulled out too far and dropped.
if any binding is detected, loosen the six rail-retaining screws (front and rear), and repeat substeps 4 through 7.
9. for additional stability needed when transporting the rack, fasten the system drawer to the rack enclosure by inserting the two system-retaining thumbscrews through the bezel and chassis bracket, and screwing them into the rack flange.
