to replace the front bezel, do the following:

    1. open the front rack door and place the system into the service position as described in “placing the model 6c3 into the service position” on page 53.

    2. seat the two tabs located on the bottom edge of the bezel into their mating slots located on the bottom edge of the system.

    3. pivot the bezel up, aligning the release tabs to the mating slots located on the front of the system.

    4. gently push the tabs into the slots until the bezel seats against the front of the system.

    5. if needed, replace the system-retaining thumbscrews.

    6. push the system drawer back into the operating position as described in “returning the model 6c3 to the operating position” on page 55.

    7. close the rack door.