this section describes some points that need your attention before proceeding with any installation.

    be sure to disconnect the power cord before installing and/or wiring your eds-405.

    calculate the maximum possible current in each power wire and common wire. observe all electrical codes dictating the maximum current allowable for each wire size.

    if the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your equipment.

    you should also pay attention to the following points:

    1 use separate paths to route wiring for power and devices. if power wiring and device wiring paths must cross, make sure the wires are perpendicular at the intersection point.

    do not run signal or communication wiring and power wiring in the same wire conduit. to avoid interference, wires with different signal characteristics should be routed separately.

    2 you can use the type of signal transmitted through a wire to determine which wires should be kept separate. the rule of thumb is that wiring that shares similar electrical characteristics can be bundled together.

    3 keep input wiring and output wiring separate.

    4 where necessary, it is strongly advised that you label wiring to all devices in the system.