winetool provides network adapter information, generates specified packets, captures packets, and analyses network traffic.
both the etherguard and winetool software installation procedure is the same. the screens shown here are for theetherguard program. to install the software:
1. insert the cd-rom into your cd drive.
2. select the etherguard or winetool folder, then double-click the “setup.exe” file under the folder. a “welcome” screen will open.
3. click “next.”
4. click “yes” to agree to the license statement. an information screen will open showing the minimum system requirements needed to run the program.
5. if your system meets the requirements, click “next.”
6. on the “choose destination location” screen, click “browse” to install the program files into a folder other than the default, or click “next” to install to the default folder shown on the screen.
7. choose the location where the program icons will be located and click “next.”
8. check the “to launch etherguard” box and click “finish” to complete the installation and launch the etherguard program. the etherguard program may also be started by clicking “start/programs/etherguard/etherguard.” the program will start and then run in the background. a globe icon will appear on the toolbar (see the figure on the next page). double-click the icon to bring the program to the foreground.
see the following section for etherguard configuration instructions, or go to “winetool” on page 23 for winetool configuration instructions.